- SATA and PATA - co-exist?
- Posted by Bobby on April 2nd, 2005
I have set-up a new SATA drive as my boot drive (some of you will know that
it's been a long story ;-)
I want to use my old PATA (Maxtor ATA 133) drive as a slave.
But I can't find a jumper setting on the old drive to do this. Two settings
(MASTER and CS) make it my boot drive and the other two settings (I forget
what they're called) make the drive invisible to Windows (XP, SP2).
Is it possible to do what I want to do?
If so, how?
Cheers.
Bobby
- Posted by RBM on April 2nd, 2005
It wouldn't be a slave to a sata drive, so unless you are setting it as
slave to another ide drive, make it a master and in the bios, disable it as
a boot drive
"Bobby" <bobby@aventuremail.com> wrote in message
news:3b7bc1F6gd3o4U1@individual.net...
- Posted by kony on April 2nd, 2005
On Sat, 2 Apr 2005 11:44:16 +0100, "Bobby"
<bobby@aventuremail.com> wrote:
Slave setting removes all jumpers, IIRC, but I'd just jumper
to Cable Select, that IS why it's there (and how most drives
arrive from factory too).
- Posted by Mike Walsh on April 2nd, 2005
Make the PATA drive master. Configure the system BIOS to boot from SATA (it might be listed as SCSI) before IDE.
Bobby wrote:
--
Mike Walsh
West Palm Beach, Florida, U.S.A.
- Posted by Timothy Daniels on April 3rd, 2005
"Bobby" wrote:
Why do you want to make it a Slave? What would that do?
In the P-ATA world, all that does is make it second to
whatever is the Master in the *default* HD boot priority,
and that priority is arbitrary and can be rearranged by
manual selection in the BIOS. But relative to S-ATA drives,
Master/Slave has no meaning, and the default boot priority
is set by a different rule.
*TimDaniels*
