- Seagate 320GB Sata Problem
- Posted by jjaco_ph on February 29th, 2008
Need your help:
I had a seagate 320GBsata drive which failed in less than a year. My
hardware setup: P4 2.6ghz on ASUS P5GL-MX, Nvidia 6600 LE, Leadtech TV
card and a DV card. Symptoms include: bios not detecting the drive
intermittently. Itried using the seagate tools but it failed the test.
I got a replacement from the dealer and the 320gb has no problem. Then
after almost another year(but short of 4 months) the drive is again
showing similar peoblem as my previous drive. Now, I have upgraded to
E4500 and an EMAXX 945GC-1333, 7300GT 128bit-256mb ddr3. By the way, my
primary boot device is an 80gb IDE drive. The 320gb drive is showing
the symptoms of the first 320 drive I got after a large file had been
copied in it or heavy read/write on this drive. (I'm into video
editing)
What's happenning with the Seagate drive? Is it somekind of a
manufacturing defect since both drive experienced the same problem?
Thanks,
Jo
- Posted by borepstein@gmail.com on February 29th, 2008
On Feb 28, 11:54 pm, jjaco_ph <jjaco_ph.35j...@no.email.invalid>
wrote:
It could be that the drives are a bit shaky and you simply wore both
of them out by using them heavily during video editing. This is not a
very intelligent guess but it is the best one I can come up with at
the moment.
Boris.
- Posted by CBFalconer on February 29th, 2008
jjaco_ph wrote:
My pure guess is that you are running them too hot.
--
[mail]: Chuck F (cbfalconer at maineline dot net)
[page]: <http://cbfalconer.home.att.net>
Try the download section.
--
Posted via a free Usenet account from http://www.teranews.com
- Posted by Alex Mizrahi on February 29th, 2008
jp> What's happenning with the Seagate drive? Is it somekind of a
jp> manufacturing defect since both drive experienced the same problem?
if you're using them with same PSU and chassis, it might be a problem of
your system:
PSU not giving enough power or drive got too hot w/o proper cooling.
- Posted by Gary Sams on March 1st, 2008
I have had a problem of going through a hard drive, of various makes and
sizes, every 12 to 18 months. My local computer wizard blamed it on the
flashing lights on the side of my case. He says he always disconnects them
because he thinks the electrical flickering can cause long term problems.
Sounds a bit unlikely to me, but to be on the safe side I have replaced the
case, the motherboard, and the PSU. They were getting on anyway, and I can't
stand the hassle of another fried hard disc,
Gary
"jjaco_ph" <jjaco_ph.35jo48@no.email.invalid> wrote in message
news:jjaco_ph.35jo48@no.email.invalid...
- Posted by VanguardLH on March 2nd, 2008
"jjaco_ph" <jjaco_ph.35jo48@no.email.invalid> wrote in message
news:jjaco_ph.35jo48@no.email.invalid...
Did you pack the hard disk right next to other drives? Or did you
make sure there was space on each side of the hard disk to let it
dissipate its heat?
- Posted by VanguardLH on March 2nd, 2008
"Gary Sams" <gary_sams@bigfoot.com> wrote in message
news:95adnXVpxbfZwlTanZ2dnUVZ8sKlnZ2d@pipex.net...
So what is the label on those hard disks? Gremlins? "Oooooh, bright
light, bright light."
- Posted by GT on March 3rd, 2008
"Gary Sams" <gary_sams@bigfoot.com> wrote in message
news:95adnXVpxbfZwlTanZ2dnUVZ8sKlnZ2d@pipex.net...
I would stop referring to him as a wizard if he thinks flashing lights will
affect a hard drive. He is not a wizard - more a witch doctor! The only
flashing light that would affect a hard disk would be a lightening strike.
I agree with all the other diagnosis here - probably overheating due to: 1.
no movement of air around the drive. 2. drives packed together too close and
heating each other too much. 3. Generally too hot case.
- Posted by kony on March 4th, 2008
On Mon, 3 Mar 2008 11:28:39 -0000, "GT"
<ContactGT_remove_@hotmail.com> wrote:
No mention was made of the power supply, if it is overlooked
as being potentially important then perhaps similar
oversight caused use of one that isn't very good.
I suppose the OP could just be very unlucky or have a (UPS,
Fedex, etc) delivery man that likes to play soccer with
packages.
Also if the drives keep failing it might be good to at least
implement a RAID1 array so it doesn't cause reoccuring
downtime, though if the PSU is marginal that addt'l load
might make the problem even worse.
- Posted by ~misfit~ on March 8th, 2008
Somewhere on teh intarweb "jjaco_ph" typed:
I can think of four likely reasons for failure:
1) Heat.
2) Warmth.
3) Temperature.
4) Thermal.
Those are most likely causes by a factor of 95.732%
Another possible reason is that the drives could have the AAK firmware which
is optimised for boot drives rather than data drives. (Although I can't see
how this would cause failure, more like just slow operation with large
files.)
--
Shaun.
