- "The BIOS in this system is not fully ACPI compliant"
- Posted by Ratzz on June 11th, 2005
Hi all,
My 300w PSU failed yesterday so I bought a new 350w one today.
Installed it and it booted into windows ok.
After about 5 minutes of using the PC I got the BSOD and the above error.
I've tried diabling ACPI in BIOS but with no luck. Will not boot with safe
mode (fails after mup.sys and re-boots). Will not boot with last known good
config.
Any help?
Ratzz
[Windows XP, Athlon XP 2.5, 768mb mem (three banks), two HDD, two DVD/RW,
AGP graphics card, other PCI cards]
Similar Posts
- Can I "RE-Flash a BIOS" to fix a BIOS I "upgraded" with the wrong file? (Microsoft Windows) by Talahasee
- Aspire laptop restoration/recovery fails: "THE SYSTEM IS NOT FULLY INSTALLED. PLEASE RUN SETUP AGAIN" (Laptops/Notebooks) by synodinos@gmail.com
- Bios is not ACPI Compliant Stop Error (Computers & Technology) by T.B.
- XP problem - error message "ACPI BIOS is attempting to write to an illegal IO port address" (or read from) (Computers & Technology) by URSUS
- Compaq Armada 7400 BIOS not ACPI compliant (Laptops/Notebooks) by gump33lt

