I'm having a real heck of a time with this chip, the TI ADS1256 A to D
converter. Has anyone else here programmed this device before with a uC
.. I am using an atmel atmega 162 . All of my outputs look alive and
well, and the ADC sends back semi random data when I attempt to just
read a configuration register. If anyone here has example code (pseudo
code, assembler, c, any processor) I would be relieved to just see some
example of the proper sequence or timing. I've been through the data
sheet several times and have cut back from a complete configuration and
data acquisition to a very simple "what's in this register" and still
don't have it working. TI doesn't have any examples of coding on their
website as far as I can tell. I'm truly at a loss here, as the signals
all look fairly clean (SPI signals), as far as I can tell I'm sending
the right sequences and still I just get random gibberish from the
chip. Thanks!

fenriswolfnews@hotmail.com wrote:

The signals look fairly clean ? They have to be
identical to the datasheet. With matching timing.

Some ADC requires some idle time after a reset.
But this will also be mentioned in the datsheet.

Meaning you will have to actually measure your
SPI signals and compare each detail with the
datasheet. Not just the timings, but also the
written details

Rene
--
Ing.Buero R.Tschaggelar - http://www.ibrtses.com
& commercial newsgroups - http://www.talkto.net