On Oct 6, 11:37 am, "Tom Lucas" <news@REMOVE_auto_THIS_flame_TO_REPLY.clara.co.uk> wrote: I'm an engineer and I come with a low pass marketing filter installed. So that suggestion is lost. Wait for...

*** top-posting fixed *** dick wrote: Mr Bourne gave you one possibility. Please don't top-post. I fixed this one. Your answer belongs after (or intermixed with) the material you quote, after...

Rob Horton <yahoo@mr_horton.com> wrote: Probably some people started considering it. But I bet most stopped the moment they realized that USB isn't really a network, by any stretch of the meaning...

manoj wrote: r7 Assuming you're using C51

Eric wrote: Probably the same problem. With 1.5V core, 2.5V DDR and 3.3V I/O, the jtag lines should be between 1.5V and 3.3V. I have seen similar requirements with jtag at 2.5V. In any case,...

giangiammy wrote: The trick is to do the JIT on the PC and only download native code to the device. Look for a native cross-compiler. This is somewhat...

This is just ridiculous. Personal aguments between two people posted in 75 newsgroups all over the world.

MGM Systems wrote: It should still be easy to locate. Many of these cards use the NS "Boomer" IC. Look around the place where audio egresses the board.

hi, i want to generate vxworks bsp in xilinx edk after clicking down the "generate library and bsps",the following error comes to...

Thanks for all!! Finally I found local distributor who has 3 boards I'm interested in to sell. Marcin

Leon wrote: The free offer seems to have disappeared, they probably haven't got any left. Leon

Hi. Take a look at Maxim. They have a uC (with MAC) that has TCP/IP firmware included. You just need to add a PHY chip. http://www.maxim-ic.com/TINIplatform.cfm Hernán Sánchez

Rodo wrote: You MEASURE the bit rate. The transmitter data rate will vary according to range , battery level, temperature, etc. The preamble (the "header") allows you to measure the timing of the...

jacko wrote: 53% of MAX II EPM570T100C5 at 303 LEs with modification of interrupt handler to swap only P reg. Looks good, but still unverified. Ummm. will i get all the nice io in the 47% left? cos...

Joerg wrote: I think I'm headed the same way. I've already given up on 71V416 and am getting similar Cypress parts. I refused to pay $10 per order line at arrownac.

Klaus Kragelund <klauskvik@hotmail.com> wrote: It's not a DSP term. It's just a bit of short-hand for "use a numerical optimization technique to maximize...". -- Hans-Bernhard Broeker...

glen herrmannsfeldt wrote: No. Gauss' work was not published until 1866, as a part of his collected works. Prior to that, there were various authors who published related algorithms (e.g. a paper...

On Oct 4, 5:08*pm, "ivan" <wolfsaf...@wolfsafety.it> wrote: Pretty much all them can do that, try to come up with a more specific spec.

Steve Calfee wrote: My preferred suite (i.e. what I use for my own work) comprises: stand-alone editor gcc/mingw and make/gnubinutils gdb Another thing I like about the above is that you can...

problem solved, thanks for your help. and for all those who use an altera development kit: you need to set the power supply enable pin to high to make the display work. i think that's not obvious if...