Hi All, Here is a open-source CableServer replacement for Impact. Currently Parallel III and Alter ByteBlaster are supported, but any 3rd party can be implemented easily and can be used from...

"Vladimir Vassilevsky" <antispam_bogus@hotmail.com> ha scritto nel messaggio news:2HeMg.9396$yO7.1549@newssvr14.news.prodigy.com... I have it in C, but it uses Goertzel and Z8Encore is not fast...

Hi all, I am new to embedded design and I am searching for development tools for a Cirrus logic EP9315 based project.Is there any cross compiler for EP9315 other than the one supplied by Cirrus...

I see.Thanks Roland Zitzke 写�：

Hi, (There is quite a long background to my question, so I apologies in advance for a longish post.) I'm building an Atmel AT91SAM7S128/256 based product that needs to support the USB Mass Storage...

On 2006-09-06, phaeton <blahbleh666@hotmail.com> wrote: you've cleared the first hurdle, read all of this page: <http://groups.google.com/support/bin/answer.py?answer=12348> Bye. Jasen

"igor" <imalikin@stdcom.com> wrote in message news:QbednaZ7UrmILp3YnZ2dnUVZ_vednZ2d@giganews.com... <snip> Had you typed "stk500 -h" you would have seen the correct options. First of all, -F...

linnix wrote: If the AVR is running 10 mA at 8 MHz, you might be better off with an ARM processor such as the AT91SAM7S from Atmel. We did a comprehensive comparison and found that when running,...

Grant Edwards <grante@visi.com> writes: Guess I should have used a smiley :) -- John Devereux

My IXP425 at 533 MHz running Linux 2.4 perfectly bridges 64-byte frames at 7 Mb/s (=10,000 frames/s), except that it loses a couple of 100 frames every hour. Also, whenever I enter a command in the...

Surinder, Thanks a lot.. Regards, Gopal

No doubt about this. I was one of the early users of the Optxxx tools, and I still have the original "black book" tech docs for OptASM, OptLink, Optlib: the whole family. OptASM was incomparably...

so u mean that i sholud use forks as design alternative for my project ?

The frame pointer is typically not used, if used it is generally set by the compiler at function entry. You can force the compiler to use the fp by using "alloca" (allocate memory on the stack) call...

Donald Harris wrote: Hello Don, Thanks a lot for your offer! But thanks to Miklós, I now have the full PDF datasheet, so there is no need to break the binding of your databooks. :) Thanks again,...

"rickman" <gnuarm@gmail.com> writes: I once spoke with an arrogant a**hole of a recruiter asking about ambiguous job requirements for a position he'd advertised. He informed me that he made...

"Vivekanandan M" <vivekm@sankhya.com> wrote in message news:1157440560.214217.108650@i3g2000cwc.googlegroups.com... Also true for on-chip hardware interrupt sources. Not true. The timer interrupt...

Steve at fivetrees escreveu: This is all true ... however, since this thread acknowledges that xml parsing is common in embedded, I'd prefer to solve the issues particular to this project, rather...

Hi everyone, I am having some problems with with my TI F2812 SCI. I get RX overflow errors about half the times I start my program even though I reset everything in initialization functions. It is...

We are looking to buy databases in the following industries * Pharmacy * Poker * Bingo * Casino * Sportsbook * Backgammon We will pay top $ for data