Compact Flash Card Users! We have developed a card reader/writer for Compact Flash (and other cards) as part of a bigger controller chip my company designs. For Compact Flash, we have been using...

Hi ; when i configure PINSEL0 to use port 0.14 as externel INT1 the pin goes low why ? johan

Weird issue, but I can't receive data using the TWI module in the ATmega128. (Writing data is documented very well in the datasheet, reading data is not). The code I'm trying to use is below. It...

Hi All, Does anyone know of a free MPEG4 encoder library suitable running on an ARM Linux system? My boss wants to see if it's going to be feasible to do this in software and avoid needing an MPEG4...

Greetings, I am having some problems with the UART protocol. To my limited knowledge, I know that the UART is capable of handling more than the usual 8 data bits. I would need the OMAP to receive 20...

After the requirements for a new application are known and a prototype shows the minimum requirements, 1) how to select the right=smallest=cheapest controller? 2) Are there any vendor independent...

Can anyone suggest a motherboard similar to the EValue ECM-5715. I am trying to find out what options are available to us. I am also looking into the VIA EPIA SP1300. The main requirements...

Hi, I used GCC-AVR to compile an example, but there are some errors as in the following. The errors are of the same types. I felt that the compiler cannot substitute the definitions to the...

Can anyone help me on keychain remote coding. i know about rf transmitters and recievers, i have used these with encoders and decoders. but this is not secure. i have heard about keyfob transmitters...

A client has requested unique wire colors for ~70 wires in a harness. I figure that at least 90 colors ought to be readily available (standard 10 "resistor band" colors plus stripe combinations)....

Two Toshiba TC58V64AFT 8Mbyte NAND flash chip in TSOP44 package. Sealed in original Digi-Key moisture barrier bags but they are practically five years old. Free parcel post shipping inside USA, will...

Application is an industrial controller 3V I/O Around 4M x 16 density TSOP (for preference) or BGA (if I must) What devices did you use recently ? Any problems technically or with...

Hello Everyone, I recently inherited a design based on Infineon C167 microcontroller with Rigel Reads 3.1 software to program it. I have never done any microcontroller programming before and since...

Google Groups is being recalcitrant these past couple of days, so I have no idea if the world will see this, but I've just released free C source to my embedded FAT filesystem. I've tested this code...

I'm thinking someone must have developed a Windows/USB debugging tool that can read out the descriptor data downloaded from connected devices. Anyone know of such a tool?

Dear colleagues, please consider submitting a paper to the 18th International Conference on Software Engineering and Knowledge Engineering (SEKE'06) and the subsequent special issue of the...

Dear colleagues, please consider submitting a paper to the 18th International Conference on Software Engineering and Knowledge Engineering (SEKE'06) and the subsequent special issue of the...

Hello all, is it possible to have information about configuration of ESCI module and code sample for LIN (v 1.3) master application ? Datasheet shows only about LINT -LINR (SCBR reg) config but I...

I cannot use the MSP430 ROM BSL, because the custom board, already in production, has a connector with the UARTs signals (not the hw BSL signals), and we cannot make hardware changes (it is a pity we...

Dear frends, I have MCB2140 board from KEIL and I want to connect Siemens MC35i GS modem with the same on COM1 of lpc2148. The port given on board is not fully connected as there are only two wires...