I tried searching the web, but failed to find what I need, that's wh I am posting. I am trying to get up to speed in Digital Image Processing based o FPGA design I am having hard time finding a...

Lovely. (Not.)

From: "John Scott" <j.p.scott@btinternet.com>

Guy Macon wrote: Seems like a worthwhile effort Guy. Sorry. too much else on to be a moderator but congrats on the position anyway. --

Dear All I am newbe to the ARM Processor, I dont have any Idea of ARM processor, I have to learn about the ARM processor, Please Guide me with the links and the documentation where i can find the...

We are starting to think about using this MCU, but have no experience with it. What's your oppinion ? Thanks, Toni.

I am using a Rice17A to emulate a PIC18C252. Having a lot of fun trying to debug 2 timer-overflow based interrupts. One is high priority, one is low. I can't single step because the timers keep...

Hello all, I have recently acquired a bluetooth development kit (TDK's blue2i + USB adaptor). I have successfully connected the serial ports and transferred and received the data at 9600 baud. I...

We have an embedded system, that has a SMSC 91C111 Ethernet Chip, ARM Processor, and Windows CE 3.0. Our system works great when not exposed to a "Corporate Ethernet" environment. When we put our...

Hi, I'm reading some papers about a tool which is estimating the worst-case execution time of a task. The authors make a difference among the terms "instruction" and "operation". I'm not sure about...

Hi, I have a written a Linux driver to control a parallel port (bit bangs data serially) and I want to port it to windows. The Linux device driver is pretty simple, just a few ioctls and that's it....

Hello all, I am designing a board which validates the PCI/PC-Card(16bit)/CardBus3 interfaces of a chip.I have a processor chip which can act as a PC-Car and PCI host controller, but it has no...

I am using MSP-449STK-2 as my studying kit. There was serial ports on the board and my laptop. May I just connect them together with a serial cable and write programs to send data to the MSP430F449...

Hi everyone! First of all I am sorry for my poor English... I'll try to be clearer than I can! I have the following problem: I want to simulate by means of Pspice an entire CAN bus with many nodes...

Hi , Im trying to port linux to a custom board i designed (based on the AT91RM9200 ). But im faced with a problem - after the execution of the kernel is started , at the very first instruction , i...

Update to following job posting. You can contact me directly a 512-381-3764. E-mail: sgarteaga@sigmatel.com. Firmware Developer Design and implement firmware for the SOC firmware development...

HI... I am programming with a MAVRIC II that uses the ATMEGA 128 but I connect GP2D12 infrarred sensor to the UART and I use the hyperterminal for see th output of the sensor but the only thing that...

Hi, Could I print debug message in the AVR Studio output window? I found the GCC has a header file stdio.h which contains printf. But could it be used? Thanks!

Firmware Developer Firmware Developer Design and implement firmware for the SOC firmware development team. variety of areas of programming skills may be used in this positio including device drivers...

We are using 4GB IDE memtech flashdrives in one of our embedded devices. We have had about 10% defective among those used under normal conditions by our customer. During the qualification,...