I'm using an ST FLASH, M29W800, which appears to be equivalent to the AMD Am29L800. I've tied the reset line directly to 3 volts. I can't get the device to work, checked all the signals with a cro....

Please take a few minutes to take this 8/16 bit embedded programming tools survey: http://www.surveymonkey.com/s.asp?u=16079312463

Someone suggested that I post this under a separate heading in order to make it more visible for those who might be looking. Sorry for the duplicate post. I own a small company that manufactures...

Hi, I am implementing a circuit which utilises a single port as a bi-directional data bus (writes data to #3 74ls373s and reads data from #2 Max6818 which have tri-stated outputs) My question is as...

Hi, when using linker scripts, how can you check if the various sections actually fit into the specified memory regions ? Thanks, Tom

Hi, I have an application that among other things has to detect the current of an industrial machine. Basically the micro controller has to determine if this machine is idle (drawing low current)...

Hi I'm a VC++ programmer doing my first bit of embedded development in C for a 80C52 compatible chip. I have the use of some API's and included is an .h file containing the following...

I have one of the LED_SWING examples working that is written in C. I'm using cygwin and gnu tools. I'm looking for some simple examples for further study, preferably written in C. 1. A simple...

the simple LPC2106 design

Please if you aren't from Croatia do ignore this post. Da li ima koga tu iz Hrvatske, zanima me cime se ljudi kod nas jos bave i sl.? Tek toliko, znatizeljan sam?

I'm using Microchip's MPLAB IDE 6.20 to link several assembly routines into a control program for a system bus/memory interface. Everything would be fine, but when I run a Build All, I get the...

Hi all, Can anybody give me some idea.. what is the basic difference b/w Boot chip select and normal chip select for a microprocesor/microcontroller. If I am not wrong boot cs : Restricts itself to...

I bought a pedometer a few days ago to get an idea of how far I walked in a day, with the intention of monitoring my daily activity. (E.g. search for "10,000 steps" on google.) I've been through...

Hi, I need to source some memory for a Motorola MCG MTX board. The data sheet gives the following spec: EDO 168 Pin DIMM 3.3V unbuffered

I am looking for foreign manufacturer of the Mail Station sold by Earthlink and designed by Cidco. I am particularly interested in the LCD of the device. Any technical information or other insight...

Can anyone advise me on the best design path for the following circuit? I am assuming micro with internal flash memory, unless someone has a better option. Criteria: 1. Ability to upload a single...

Hi All, I'm a hardware electronics designer, with a lot of experience in complex FPGA/CPLD design and some in programming in C (primarily embedded controllers). I'm now looking to do some PCI...

Hi all, I am facing problems in estblishing 3 wire interface between R2061 seies RTC and ADSP 2188.I have followed the potocol mentioned in the datasheet.Still RTc is not responding.If any one has...

Hello, I'm trying to use RTL8019AS for my embedded project. I can initialize the chip properly, read and write to the registers without any problems, but when I try to send data to its DMA buffer,...

Hi, Is there a way to do 1200 or 2400 baud with an 8 or 16 bit microcontroller? I have an application that requires modem communications. In the past I have done 110 - 300 baud half duplex with an...