- Suggestions for Plastic Molding Case for Embedded Project
- Posted by Ben Nguyen on March 2nd, 2004
Im laying out a PCB and Im looking to have a simple plastic casing
around it.
This is just for my senior project, so Im not looking for high volume (cost)
production.
The case would just need to be the size of the card (~ 4" x 2") and some
room for a few double aa batteries.
Can anyone recommend a company?
- Posted by Spehro Pefhany on March 2nd, 2004
On 2 Mar 2004 15:23:08 -0800, the renowned benn686@hotmail.com (Ben
Nguyen) wrote:
You're apparently in Orange County, CA, USofA. Check out online
distributors such as Mouser.com and Digikey.com and get the actual
datasheets from the manufacturers such as Pactec, Hammond, Serpac etc.
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@interlog.com Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
- Posted by Richard on March 3rd, 2004
Spehro Pefhany wrote:
Better yet, stop by your local Fry's Electronics. They stock a decent
collection of enclosures, - Pactec's, I think.
Or, Radio Shack used to sell small project enclosures in blue ABS and
metal. Might still.
- Posted by Spehro Pefhany on March 3rd, 2004
On Tue, 02 Mar 2004 19:06:31 -0700, the renowned Richard
<rh86@azglobal.com> wrote:
Depending on the Fry's, I guess. There's also All Electronics way up
in Van-eyes.
If not, radioshack.com does.
Best regards,
Spehro Pefhany
--
"it's the network..." "The Journey is the reward"
speff@interlog.com Info for manufacturers: http://www.trexon.com
Embedded software/hardware/analog Info for designers: http://www.speff.com
