- Moving Internet to new room
- Posted by c_sicker@yahoo.com on April 23rd, 2006
We have decided to move our high speed internet cable modem to a new
room in our house. We have a cable outlet in the new room but was told
we need to activate it for the internet rather than the TV before
using. Of course, Charter wants to charge us an activation fee and time
for the repair person's visit. We want our main computer hooked up
directly to the cable rather than the wireless option and we do not
want to run ugly cable wire along the walls from the upstairs internet
activated cable outlet (where the internet connection is now) to the
new room downstairs where we want to reconnect our modem to.
Can we activate the cable ourselves somehow since we already have the
service and modem, or do we have to pay these jerks even more money
just to move our modem location.
Many thanks
Clyde
- Posted by riggor99999 on April 23rd, 2006
<c_sicker@yahoo.com> wrote in message
news:1145823786.561282.208430@g10g2000cwb.googlegr oups.com...
I don't have charter...but typically - they put a splitter on the cable feed
as soon as it enters the house. One feeds the TVs, and one feeds the cable
modem. You should not hang the cable modem off the TV runs since it can
cause signal problems. You want a dedicated run for the cable modem.
All you need to do - is find the run from the room you want to move to - and
re-wire accordingly where it enters the house / all the splitters are. Make
that run the direct run.
If you want to watch TV in that room and only have that one run - put a
splitter on it in that room - one to the TV and one the cable modem (yes -
everyone - I know - not recommended). The ideal choice is to have two diff
runs - one for TV and for internet.
You know - wireless would be the way to go - why don't you want wireless?
- Posted by Gary on April 24th, 2006
<c_sicker@yahoo.com> wrote in message
news:1145823786.561282.208430@g10g2000cwb.googlegr oups.com...
There is no big difference between a "TV" outlet and an "internet" outlet.
Typically, the difference is fewer splitters between the outlet and the
cable feed. In short, too many splitters are bad for cable modems.
Just try the modem on the "new" outlet. If it works, you're done. If not,
you can mess around with the splitters as another poster has suggested.
-Gary
- Posted by bjweller@gmail.com on April 24th, 2006
I would not be using the TV off this cable outlet, just internet. I do
not want to use wireless because sometimes I shut it down when my
teenager is banned from the internet due to abuse/misuse of this
priviledge.
- Posted by c_sicker@yahoo.com on April 24th, 2006
I will not be using the TV in the new room, just internet.
BTW, the internet connection upstairs does not have a "splitter" that
I can see. It is not wired for both TV and internet service, just
internet. He told me at the time I could not use the TV on this
connection. Now we want TV in this room and internet downstairs. What
would the "splitter" look like in this instance? The cable wire
existed when he came to the house and originally set it up for internet
service. I can't remember if he replaced the wire. I do not see where
he cut the cable (although there is a additional cable leading up to
the PC because the original cable was too short.) Could the splitter be
inside the wall at the outlet junction? Are there any wewbsites that
explain (preferably with diagrams) how to do this?
- Posted by Warren on April 24th, 2006
c_sicker@yahoo.com wrote:
Typically, only one cable is dropped from the pole, or buried in your
yard. If you have more than one cable outlet in the house, it must be
split, right? One line can't become two (or more) outlets unless it's
split somewhere.
Where the splits occur can differ even between identical houses in the
same subdivision. They might be located so the least amount of cable is
used. Or there may be a central point from which a cable goes to each
outlet, even if that means cables run parallel to each other for some
distance. Or it might be a combination of the two.
The splitters, theoretically, could be inaccessible, but it's unlikely
(unless a wall was built at a later date than the house was cabled-up.)
They might be in a crawlspace instead of out in the open, or you might
need a ladder to get to them, but they're not likely to be inaccessible.
Find where the cable comes into the house, and look from there.
--
Warren H.
==========
Disclaimer: My views reflect those of myself, and not my
employer, my friends, nor (as she often tells me) my wife.
Any resemblance to the views of anybody living or dead is
coincidental. No animals were hurt in the writing of this
response -- unless you count my dog who desperately wants
to go outside now.
Power Lawncare Tools for Spring Clean-up:
http://www.holzemville.com/mall/blackanddecker/
- Posted by c_sicker@yahoo.com on April 24th, 2006
X-No-Archive
Found the cable box but of course it is locked with some sort of flimsy
lock. It is a small, very thin (1.5" x 0.75") black base with a thin
silver wire going around it in a half eclipse shape. It is not key
driven. I could cut it easily, but there are all sorts of warnings
about doing this. Any work around ideas?
- Posted by Gary on April 25th, 2006
<c_sicker@yahoo.com> wrote in message
news:1145896741.286819.97000@i39g2000cwa.googlegro ups.com...
Have you tried the cable modem in the "new" room yet? That should have been
the *first* thing you did. It's easy to do and won't break anything. If it
works, you're done. If not, then come back here for more advice and
suggestions.
-Gary
- Posted by $Bill on April 25th, 2006
c_sicker@yahoo.com wrote:
Go to where your cable comes in the house and start writing down everything
you see (esp. splitters and such). Draw a stick map in your favorite editor
and label all the components and wires to rooms, TVs, modems, etc
Cut-n-paste the map into your next post.
RG6 cable
|-----------------> Modem
Incoming cable |
---------------|<-- Signal Vision Inc. SV-4G digital 4-way splitter (5-1000Mhz)
| +7dB on each leg
|
|-----------------> TV1 (RG6)
|
|-----------------> TV2 (RG6)
|
|-----------------> (terminated at splitter)
etc, etc.
- Posted by c_sicker@yahoo.com on April 26th, 2006
I can't access it to see because where the cables join is inside a grey
box in my garage which has a flimsy lock on it. What would happen if I
cut the lock? I would not be pirating anything since I am already
paying for the service, just moving things around. Any ideas where I
could get a similar lock (described in previous post)?
$Bill wrote:
- Posted by c_sicker@yahoo.com on April 26th, 2006
Yes it was the first thing I did but it was a no go. How much trouble
will I get into if I break the lock at the box where the cables come
into the house and move things around myself. I'm not pirating
anything, just moving stuff around. Am I the only one who has a lock on
these things. Those posters suggesting checking the splitter never
mention locks so I assume they have direct acess to their splitters.
Tough break for me I guess. Geez Loise.
- Posted by $Bill on April 26th, 2006
c_sicker@yahoo.com wrote:
No idea. I'm on Comcast orig. then Adelphia and soon to be TW and
never had a box or lock.