- Epson Stylus 580 won't take paper....
- Posted by Champagne Charlie on April 28th, 2004
I have an Epson Stylus 580 printer. It's been on the other end of my PC for
a few years now, but never been used much, mainly because it's a pain in the
butt to get it to actually take the paper. It's a top-loader and feeds the
page out the front, but every time I put paper (or card) into the top
loading part, it starts to make all these banging and loud snapping sounds.
I'd put my fingers in, but I might not get them back! The thing is, it has
done this ever since I bought it and it can take about 6 attempts to get it
to take the page and print something on it. It's actual print output is
great though, it's the paper loading that's the problem. Anyone know if this
is a common 'fault' with Epson printers, or even just this particular model?
I was thinking of buying a new printer, but then wondered if I should
consider Epson again!
Any advice much appreciated.
TIA.
C.C.
- Posted by Jim on April 28th, 2004
I have never had this problem with either my Photo 700 or my Photo 1280.
Jim
"Champagne Charlie" <FreeSoft@(SkipTheBrackets)Tiscali.co.uk> wrote in
message news:utCjc.72$2g7.58@nurse.blueyonder.net...
- Posted by Burt on April 28th, 2004
I have a stylus color 900. It makes similar noises when I place one piece
of paper in the top load feed tray. Apparently a single thickness of paper
or card stock does not always trip the sensor to tell it there is paper in
the printer. The noise is repeated attempts to "find" paper on which to
print. The trick is to either use a medium to heavy piece of card stock as
a backing or put several sheets of paper in the feed area prior to printing.
Then it works just fine. Try it.
"Champagne Charlie" <FreeSoft@(SkipTheBrackets)Tiscali.co.uk> wrote in
message news:utCjc.72$2g7.58@nurse.blueyonder.net...
- Posted by Ototin on April 28th, 2004
On Wed, 28 Apr 2004 01:02:40 +0100, "Champagne Charlie"
<FreeSoft@(SkipTheBrackets)Tiscali.co.uk> wrote:
Please elaborate. Does the printer attempts to load the paper as soon
as you put a paper into the top loading part?
The paper should be loaded into the top loading part, adjust the left
paper guide so that it is snug against the paper. Also make sure that
the paper support, the part attaches to the back of the printer, is
installed.
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----
- Posted by Ototin on April 28th, 2004
On Wed, 28 Apr 2004 04:10:01 GMT, "Burt" <sfbjgREMOVE@pacbell.net>
wrote:
The Stylus Color 900 does not have a sensor to detect whether there's
paper loaded or not in the paper tray. However, there's a sensor that
is used to detect if the paper has been properly loaded into the
printing position.
The usual cause of misfeed is that the paper load rollers are dirty
and/or worn.
-----= Posted via Newsfeeds.Com, Uncensored Usenet News =-----
http://www.newsfeeds.com - The #1 Newsgroup Service in the World!
-----== Over 100,000 Newsgroups - 19 Different Servers! =-----
