Hello! I have following configuration on cisco 3660 on one side : l2tp-class sberbank pseudowire-class eth-sberbank encapsulation l2tpv3 protocol l2tpv3 sberbank ip local interface Loopback0

On 11 May, 22:47, Merv <merv.hr...@rogers.com> wrote: Probably it was not clear in my posting but it is the ipAdEntIfIndex which are wrong ie there are ipAdEntIfIndex=0 returned by an snmpwalk. The...

Is the router for VLAN 4 directly connected to port gi 0/4 ? Check if the router for Vlan 4 is sending CDP on interface Gi 0/4 sh cdp nei If it is being received then check if you continue to...

Merv a écrit : HangaS a écrit : Hide quoted text - the vpn client to manage access w/wo a policy pushed by the routeur (tunnel end point on branch side) You have to manage static routes on the...

Perhaps you need to get rid of the current startup config ??? The loader reads the boot commands contained in the startup config file. from ROMMON set the config register to ignore the startup...

Merv a écrit : I'll let you know Thanks for your help Thanks also to trendkil for his answer

need ccna vedio leture

On May 11, 6:36 am, "tg" <t...@nospamevereverever.net> wrote: see Cisco doc "Configuring Repeater and Standby Access Points and Workgroup Bridge...

Thanks, that's precisely what I wanted to know. Best regards, Tiago On May 11, 3:22*am, "John Agosta" <jago...@wideopenwest.com> wrote:

An ISDN PRI is a T1 that is running the ISDN protocol. Same concept as an MPLS or frame-relay circuit. A T1 is a WAN point-to-point circuit and ISDN is a voice signaling protocol. MPLS and...

Pandaeatsbamboo <mr.wong.and.mrs.wong@gmail.com> wrote: Blimey do we have to wait that long for reruns of the pinkey and the brain ??

2057 - The Body http://pandaeatsbamboo.blogspot.com/2008/05/2057-body.html

In the message <0fe40acf-3953-4435-bcc1-4e236b529d04@c19g2000prf.googlegroups.com> tman wrote: | On May 9, 2:08*pm, Merv <merv.hr...@rogers.com> wrote: | > to disable trunking on a 3500XL, try the...

RSTP has the CONVERGENCE time around 1 second - it's time from topology change (primary path goes down) to a stable state (previously blocked redundant link goes into Forwarding mode). To speed up...

Nino, What model is your Supervisor module? Does it have a Compact Flash slot? Just get a CF flash, copy image from working Supervisor (copy bootflash:<image> slot0:), insert the flash to a standby...

oups ... "Tom Linden" <tom@kednos.company> a écrit dans le message de news: op.tyuuvx06hv4qyg@murphus...

I have a pair Edge2WAN 150's (3 WAN port) routers at 2 business location. On WAN3 at each site I am using a private address (192.168.10.1 and 192.168.10.2) and route private network between these...

Paul Smedshammer schrieb: Don't do that. The SMTP reception port 25 and the submission port 587 should be configured differently, port 587 only accepting authenticated SMTP connections and port 25...

It is buidlinbg a text version of the internal running-config compare what happens with the tow commands show startup-config notice that the config is displayed immediately - this is because...

In the message <fvvch5$oqd$1@inews.gazeta.pl> Mariusz 'BB' Trojanowski wrote: | > I'm seekeng information regarding a new purchase of Cisco Secure ACS 4.2 | > | > If we buy new Cisco Secure Access...