Does anybody know how to reset the baud rate on a Cisco 851?
I've done jumper-resets on 2600s before, but I can't find any
documentation for the 851.

When I console in, the "€" symbol runs across the screen.

I'm sure my computer settings and cables are good because I can
console into other Cisco routers just fine.

Thanks,
hack.bac

"hack.bac" <hackbac@gmail.com> writes:
You'd have to go back a bit further than the 2600 for a jumper change...

Just try each of the baud rates until you find the one it is. Then
break and 'confreg' and change it back to the default.