Hello,
I am trying to get stats from each of the interfaces on the blades and
running a quick SNMP I can get the VLAN stats but not the Interface
stats.
Could anyone give me an idea on the OID to check?
Thanks in advance
Giles

Mr Jibbles wrote:
..iso.org.dod.internet.mgmt.mib-2.interfaces.ifTable.ifEntry

32 bit counters only of course.

On a Gigbit interface the byte counters could wrap in
let's see .... 30 sec, or of course 15 sec if the implementation
uses signed numbers.

http://www.cisco.com/warp/public/535/3.html
says:-
In SNMPv2, 32-bit and 64-bit counters are defined

If you find the 64 bit ones let me know.

Thanks for the quick reply.
This is the OID I was using (1.3.6.1.2.1.2.2.1) and it only displays
the VLANs. If I do a 'show port' on the console it shows the individual
ports (slot/port). These are the stats I am looking for. Does the Cisco
6500 have 2 MGT ips (one for the routing engine and one for the
switch)?

anybody43@hotmail.com wrote:

..iso.org.dod.internet.mgmt.mib-2.interfaces.ifTable.ifEntry
and
..1.3.6.1.2.1.2.2.1

are equivalent

I have been out of 6500s for a while however if you have
a router module (MSFC) and you are running CatOS
on the switch then they will indeed have seperate IP
addresses.

I forget how that config works now.

That would explain what you see. If that is the case you will
need to configure snmp (Assuming it has an IP address)
on the Supervisor Engine and you will then be able to get
the stats from there.

The sup 720 I believe has a single manegement entity.
Will find out shortly