Hi

Please help me to make myself clear that it is possible to set a soft
loopback from any cisco router itself.

Tnx.

scilent-project skrev:
Not entirely sure if this is what your asking but to configure loopback
interface
simply create it by going into configure mode and type: interface
loopback0
or any other number you choose.
Then configure IP addressing and other stuff as normal.

This can be done on all cisco routers, running IOS, I think.

-SAto

Thants the way we can make interface a loop back interface

Are you asking something else



SAto wrote:

NETADMIN wrote:
I think what you might be asking is with regard to a CSU/DSU loop back
on a WIC? If so then I must derive from that your goal is to bring the
network up from behind this router/interface? If so, this is not the
purpose of the loopback function of this T1 controller feature. When
you set it to "loopback", btw the soft command and the physical
pushbutton methods do the same thing, you are looping "back" to the
adjacent endpoint; usually the CO switch so that your cabling and
everything between you and the far end can be tested. I hope my
assumptions are close.

-mike