In article <bf9mnl$bc9$1@news.nationsnetwork.net>, Eric Rees <ericr@nospam.nationsnetwork.com> wrote: dialer watch-disable 1800 says to wait 1/2 hour before disconnecting after the primary link is...

I've got this router that rebooted and now shows "routername"(boot) and I can't seem to get it to boot normally. Here is the config it's booting to.. Cisco Internetwork Operating System...

Is there a way to redirect all WWW (both port 80 and 443) traffic leaving a cisco router to an Internet based proxy server. For instance, everything from the internal network would go to 66.67.68.69...

Dear all, Anybody has an experience how to redirect traffic to cache engine in this case my is CacheFlow SG-800. We have followed documentation by Cisco 3550 and WCCP on how-to and also from...

Morning All, Seriously putting the cart before the horse on this one, but based on sh ver, is there a way to determine whether a 4000 series router is a 4000 or a 4000-M? I picked one up from...

On router A, put a "ip routing" command ;) (you have a "no ip routing" in there!!!!!) Baruah <b_baruah@hotmail.com> wrote:

hi, if you want to have one big fat link between the two, you can go for portchannel (LACP/PAgP/Etherchannel) where you can have upto 8 active gigabit links acting as one virtual link with 8 Gbps...

In article <xiqRa.15607$Ma.2883928@news1.telusplanet.net>, bopew2000 @yahoo.com says... See the whitepapers on www.networkingunlimited.com It may point you in the right direction. --

Hi, We are experiencing problem with the use of the Cisco VPN Client to a concentrator VPN3000 : -A connection without user authentication (no xauth) works great -The same connection using xauth :...

The problem you may be having is what is the administrative distance of the route on the serial interface and the bri interface. You probably need to adjust the cost of the routes across the BRI link...

I would greatly appreciate it if any one could offer up any config examples or suggestions for configuring a PIX 501 running OS 6.3 to allow a MS VPN client to connect through it with pptp to the...

Ivan Van den Bossche wrote:

Hi all, I solved my problem accessing other pcs (had to add a route command on each pc). but now, I want to save the config. I tried #write memory #copy running-config startup-config

Hello all Just a quick question. I have a router that I am using for test. I want to be able to ping the ethernet although there is no cable plugged in. I believe there is a way that I can...

If interested please look at the foolowing link:- http://cgi.ebay.co.uk/ws/eBayISAPI.dll?ViewItem&item=3036437891 PS - UK bidders only please. Thanks in advance

I'd like to monitor the line card CPU and memory on a bunch of 12000 series routers. Anyone doing this?

not sure if this is the right group for this but here goes ok I have a laptop with winxp on it , i am have the following on the hard drive vpn523.2k.xp ( cisco vpn software ) . now here the thing ,...

This is a test to see if the news server I built works.

Given the custom queueing configuration or rather misconfiguration stated below (no default queue defined and no byte-count defined for queue 3), does anyone know what happens to smtp...