"proxy identities not supported" means that the subnet/host proposed for the SA do not match between the client and the pix. I have never setup L2TP/IPSEC, but check the match address acl on the pix...

Where can I find a used Pix 501 firewall?

Hi, I've just installed a Cisco 801 with a bridged real IP multilink 128k ISDN connection to Demon Internet in the UK. The connection drops every 5 minutes or so. What I would like to do is keep...

In article <3f06c356$0$227@hades.is.co.za>, Jonathan <jonathan_smit33@hotmail.com> wrote: :I would also like the Intrusion detection which is on the pix firewall to :automatically block access to ip...

I am having some difficulty understanding how to determine the effect of the burst amounts on peak bandwidth. For an easy math example: rate-limit output 8000000 1000000 1000000 conform-action...

Hi all, I have this simple config that runs on our PIX 506 for our VPN users (see below). How do I configure an IOS Router with IPSEC image to do the same function? Because there are a little bit of...

Hi, My ipv6 interface has 3 addresses - link-local , site-local & global one. clearly when connecting to global-scope destination, I will use the my global address as the source, but which one to...

Reload the ios this should fix your problem you have to find a way to point it to a tftp server it should be in the menu somewhere. As you are having issues with the menu system if you pull the unit...

Hi I am looking for a sample business plan .I am preparing to install a voip termination in Algeria .Can any one help me to have more info. Thanks .

In telephony there is a very desirable feature, that is sometimes called "hook-flash" or blind transfer. The above terms apply to analog calls; in ISDN PRI the basic behavior is the same, but the...

Try using the TFTP configuration method. You may have a bootload version, which doesn't have an actual application load on it. Jeremy McNamara Bernie wrote:

Hi Ramon, I am not very familiar with the Dialogic product and cannot comment about the function of the Dialogic IVR. But I think that your approach is the wrong one. Instead of messing with ISDN...

Bill, For your default route use this: ip route 0.0.0.0 0.0.0.0 Ethernet1 That should work assuming that you still have that interface configured to receive a DHCP address from the modem. Jeremy

Hi Saif, send me email to kobyb@deltathree.com and i'll replay you back with the ATA firmawrae, i couldn't send it to the hotmail address. Regards, Koby.

I need to capture data with bi-directional traffic on vlan 2 on port 12 for catalyst 3550. What is the right command to do this? Thanks. Best Regards, Sam

Read up cisco websites, or search around in this newsgrp ... there are plenty posts related to this "Sam Soh" <indotears@yahoo.com> wrote in...

What is the right command to configure catalyst 3550 switch so that MAC address learned on VLAN1 are pruned from the bridge table every 10 minute? Help, please. All Ip addresses and vlan can be made...