I inherited a Pix 506 and have a need to have a user (from a FIX IP) - telnet through PIX to a specific server on my network Any help for a newbie?

Dear All, If you have 2 firewalls, should you load-balance your default routes to both inside interfaces, or should you always use a resilient cluster and point to a virtual interface? Looking for...

I haven't been able to reach cisco.com for 2 days now. I have tried two different ISPs and triedto browse it on samspade.org also to no avail. Does anyone know whats going on ? I need to get some...

Hi, Im wondering if any of you guys can shed some light on this problem. I basically have a client who subscribes to a 3rd party (Net Evidence) stats service (snmp) which is showing them a constant...

This has been asked before, but with no solid answers. Cisco says its not supported. However: One thread said someone called cisco and were told 2600 will in later IOSes releases support this card....

We are trying to connect (over ISDN dial-on-demand) two 1603 ISDN routers in a peer-peer setup running IOS 12.0. I about to get involved in the problem, but wanted to do some troubleshooting...

When I do a sh ver of my router I see it has 8Mb flash. How to see if it's 1x8 or 2x4 Tom Pouce

Hello, I'm encountering the following problem ... The 64 IPs address subnet assigned to my LAN is now full and I need to add more computers in the same LAN. I've got a second subnet available but not...

SERVICE PROVIDER TRAFFIC PARAMETERS AND FRAME "SPEAK". The vast majority of service-providers provision traffic parameters such that Bc=CIR. This means that the service-provider's Tc interval = 1...

What's the mean "check=" result from output using "show access-list"? I didn't find documents on the Cisco website related to this problem... Please, Tell me the mean... thanks.

Hi all, I'm not debating the merits of moving from MLPPP to load-sharing per-packet, I'm just looking for guidance with the how-to. Would it be correct to move this config: ! interface...

Hi there, Can (and how) I use a Windows DHCP server to assign the IP-Address for Cisco's Callmanager Express?? I don't want multiple DHCP servers on the network ;-) Thnx - Edward

Hello, I have a T1 connection, both ends are using Cisco T1-WIC and using vanilla config on the interface. No link flaps, no log entries... interface stays up. For no obvious reason, the interface...

problem has been resolved! thx

I want to send the occasional email alert from our inside (inside security100) to outside (security0). Outside is connected to the DSL. Since I'm going from inside to outside, there shouldn't be...

I am trying to configure VLANs on my Cisco 4507. As far as I can tell I have everything set correctly. I have set up some new VLANs but cannot ping the IP addresses assigned to them. I haven't...

It probably depends on the Netscreen device but I'll ask anyway. We're sending a few people and laptops with Cisco VPN client software to a site where they use a Netscreen firewall. Will they be...

www.complete-answers.com

I've got two Cisco routers. Just set the first one up using ConfigMaker. Liked the interface. The problem is that with the second router, a Cisco 2524, the ConfigMaker tells me that my bios is too...

Hi, I would like to seek advise on where to put the 2nd Cisco router in the following situation: Currently the 1st Cisco 2600 is at the front right after ISP to route all to a Fortinet FW. The...