I have a 2509 as a controller to access all the devices. It works with
other devices ( from old 26xx,36xx to newer 28xx and ASA55xx ) but I
cannot not use it with the switch 2960. And I can access the 2960 via
the Cisco serial cable from my notebook. The 2960 configuration for
console is empty, like others.

Any advice is greatly appreciated.

DT

DT -

I've just been doing exactly this today, no problem.

Sorry to state the obvious, but have you checked the following?

- the 2509's port does not have some unusual settings (speed etc)

- the 2509's port permits reverse telnet

- the line from the 2509 is not somehow broken (try another)?

HTH...

Andrew

On Wed, 19 Sep 2007 14:39:24 +0100, dt1649651@yahoo.com wrote
(in article <1190209164.539075.136530@n39g2000hsh.googlegroups .com>):