- Stop setup in Safe Mode?
- Posted by JCC on January 11th, 2006
Due to an attempt to overwrite a bad hardware driver that prevented normal
boot up, I tried to reinstall WindowsXP. The bad driver is preventing setup
from running normally so this attempted fix will not work. What I need to do
now is to stop setup from continuing. I can boot into SafeMode but
immediately get a dialog that says setup cannot run in SafeMode, please
reboot. There are no other choices. Is there a method or a place that I can
end the setup sequence from the recovery console command line? TIA
JCC in San Diego, CA
- Posted by Diana on January 11th, 2006
Yes I have same problem, any help would great
"JCC" wrote:
> Due to an attempt to overwrite a bad hardware driver that prevented normal
> boot up, I tried to reinstall WindowsXP. The bad driver is preventing setup
> from running normally so this attempted fix will not work. What I need to do
> now is to stop setup from continuing. I can boot into SafeMode but
> immediately get a dialog that says setup cannot run in SafeMode, please
> reboot. There are no other choices. Is there a method or a place that I can
> end the setup sequence from the recovery console command line? TIA
>
> JCC in San Diego, CA
- Re: Safe Mode (Help and Support) by David D.
- Can't access safe mode/safe mode with command prompt (Security & Administration) by Bill Suen
- safe mode (Basics) by etrudell
- Safe mode or Safe mode with networking (Security & Administration) by Leo_Surf
- Safe Mode Help (Help and Support) by Hobo_man
