- Ir blaster not changing channels on set top box
- Posted by Tagday on January 29th, 2008
I have a Hauppage 1600 card and IR Blaster and the remote . Media center
will not recognize my remote for my dish network set top box. channel
I have gone though the learning process and and I can still not get it to
even change the channel or do anything. It does absolutely nothing when I
enter in the
channel number either using the remote or using the keyboard.
I can see the IR blaster's little bug you stick on top of the area on sensor
of the Set Top Box flashing when I enter in a command, but nothing happens.
I have went thru the set up many times and still it does not work.
I have tried moving the sensor to different places in the room.
Ive seen many posts on this but ive yet to get it to work.
- Posted by Curious on January 29th, 2008
Use you regular STB remote to make sure you have the right location for the
bug by holding it about 1/2 " away from the front of the STB until it works.
Then put the bug in the same location, again about 1/2 " away.
"Tagday" <Tagday@discussions.microsoft.com> wrote in message
news:0C725084-CEC3-4CA7-85AD-44BEF92CDD19@microsoft.com...
- Posted by Curious on January 29th, 2008
Use you regular STB remote to make sure you have the right location for the
bug by holding it about 1/2 " away from the front of the STB until it works.
Then put the bug in the same location, again about 1/2 " away.
"Tagday" <Tagday@discussions.microsoft.com> wrote in message
news:0C725084-CEC3-4CA7-85AD-44BEF92CDD19@microsoft.com...
- Posted by Tagday on January 30th, 2008
Ok I have tried that and still no luck with it.
"Curious" wrote:
- Posted by Tagday on January 30th, 2008
Ok I have tried that and still no luck with it.
"Curious" wrote:
