I am trying to set up a VPN server in a computer but, in the New Connection
Wizard, when I select in the Accept Incoming Connections button and click
Next, the wizard program hangs and nothing happens. I then need to close it
and Windows Explorer (the desktop) restarts. I get no error message or
anything.

Searching around the Internet it seems the cause may be that the Routing and
Remote Access Service (RRAS) need to be running. When I try to start the RRAS
I get an error message saying that it could not start and code -2147483576.
When I go to the event log I see error 2147483720. So it seems there is a
good chance herein lies the cause of the problem.

Any ideas?

Well, after much searching and fumbling around I resolved the issue by
removing a Bluetooth adapter. I found a page which mentioned a similar
problem and mentioned this interference. Since I did not use the Bluetooth
adapter anyway I just removed it and all its virtual COM ports etc from the
Device Manager and now the RRAS is working and I was able to set up a VPN
host which is what I was trying to do. I hope this information may be of
use to others.

Thank you for sharing your experience with us.

--
Bob Lin, MS-MVP, MCSE & CNE
Networking, Internet, Routing, VPN Troubleshooting on
http://www.ChicagoTech.net
How to Setup Windows, Network, VPN & Remote Access on
http://www.HowToNetworking.com


"GS3" <GS3@discussions.microsoft.com> wrote in message
news:4F6F1BDD-CB60-497F-8A48-1F68A41A152F@microsoft.com...